Application + Care Instructions

  • 1: Clean the Surface

    Ensure the material surface is clean and dry.

    2: Transfer Placement

    Cut your decal into a manageable size. Trim off any excess and cut as close to the overall printed design as possible (keeping the general shape of the wrap/decal).

    Make sure the transfer print is secure to the top film by laying it on a flat surface and rub with firm pressure using a squeegee tool, credit card or your fingertip.

    Peel the design transfer from its backing. Carefully place the transfer onto the material, making sure the design is positioned correctly.

    Note: The transfer cannot be removed once applied to the material. Decals cannot be repositioned and are permanent!

    3: Smooth Application

    SLOWLY peel the design transfer from the film or roll transfer film to reveal finished decal. Ensure the entire design adheres to the material surface.

    If any part of the design lifts up as you peel, go back, gently push down and rub on that area, then resume peeling.

    Your UV DTF Print is now successfully applied!

  • Simply peel, stick, rub air bubbles out, and remove top film for a permanent waterproof decal.

    To apply decal to a surface, follow these easy steps:

    Step 1: Clean and Prep
    Wash your window with soap and dry completely. DO NOT USE ALCOHOL as it will break down the adhesive.

    Step 2: Position and Secure
    Peel the backing and place on car/window. Once the decal is on the car/window, take time to push the decal onto the surface.

    Press between 3-5 minutes with palm OF HAND, using body temperature to activate the UV DTF adhesive. Doing this will make your peeling step so much easier, and decals will have less lifting.

    Transfer is NOT adjustable once it is applied to a surface.

    Step 3: Remove Backing
    Very slowly peel off the backing paper from the decal, ensuring it doesn't stretch or tear. If any part of the design lifts up as you peel, go back, gently push down on that area, and then resume peeling.

    Step 4: Smooth It Out
    Use your fingers or palms to smooth out the decal starting from the center and moving outward.

    Step 5: Activate & Cure
    DO NOT wash the finished project for 24-48 hours to allow the adhesive to strengthen on the car/window.

    *Please note we are not responsible for UV DTF transfers that are applied incorrectly or damaged during application.

  • For best results, hand wash only. Dishwasher is NOT recommended.

    No sealing is needed.

    When used on keychains, chipping can occur. Thicker designs will last longer than thin lines.

    UV DTF Stickers are great for outdoors and will tolerate most all weather with no problems at all. Safe for automatic carwashes.